Water driven OU power genertors
Water stream driven reversible electric power perpetual motion generator
The mostly human made perpetual motions systems are not of infinite motion. In spite of this mater of fact, this systems can be of long life under certain circumstances. Let us examine here one experimental electrical power generator based on water weals and water cycling. Indeed, such a construction has been applied in antic time in Italy. To get our power plant for producing electrical energy without the need of huge water accumulation, we would need one hill with the small slope and two water pools, one on the top and the other on the bottom of the slope. Furthermore, we would need the water stream road and let us say ten water weals placed after each other in order to be driven by the same water stream. Each water weal is going to drive own electrical generator. The last in chain electrical generator is going to drive the motor pump, to elevate the water upwards, from the pool down the hill in the pool on the top of the hill. The rest of the water weals in chain are going to produce the electric energy on the cost of servicing the system. Furthermore it is possible to make as many stream lines as needed including as many water weals as needed to reach the target power. The system is recommended to be situated nearby the city in order to prevent implementing of electrical power transportation road which is expensive to service. In doing so, the power grid could be reorganized to be more decentralized, which could preserve about 40 % of the total amount of funds collected for the energy nowadays.
The key of success of this experiment is a water pump. The condition for success of application lays in avoiding the thermodynamic law, introducing the additional energy into the system, which originate in environmental background field. Paying especial attention to a choice of the water pump or better expressed, to the construction of the water pump, we could be able to achieve our aims, beyond our expectations. One practical example for the very efficient water pump is a Tesla turbine based motor and pump. The turbine is made of metal disk stack, which are supplied with compressed air in closed loop. The energy needed to be invested to supply a compressor, to produce the needed quantity of the pressed air, which in turn is sufficient to supply the motor, is far less then we are able to suppose. The motor supplied by an compressed air is going to exhaust the same air quantity, which could be turned in a closed loop to the inlet introducing a jet nozzle to suck additional air from the environment. In this way one part of an energy necessary for supplying is going to be preserved. The other part of energy we could achieve introducing a resonant power, developing a motor, which is equivalent to oscillator, to mach the measures of Earth, introducing in this way additional energy in subsystem, from a background field. More details about this project could be found in article about Green-Aviation.
The long way to the top of the hill, could be crossed using a cascade of the water pumps combined with additional water tanks, on need.
This is our simple to build, low cost electrical power plant, based on conversion of the attractive planetary gravitational force and cycling the water in a closed loop up and down the hill slope.
Low power water stream driven electrical power generator
We can easily recognize the similarities between the reversible water stream powered electrical generators plant based on water cycling described above and the resonant artificial landscape made by our Art-Landtis ancestors of unknown age, but certain older then 30 millenniums, accordingly to the newest archeological reports, from Bosnian pyramids archeological site.
If we are going to successfully build the resonant landscape structures, to reshape the hills to have the plateaus which follows the contour lines of the hills, we are going to pull the groundwater upwards to the top of the hill and possibly to get the new fresh water spring close to the top of the hill. To provide the electrical energy we can build the concrete water tank just down the spring for instance two meters high and one squared meter in base, in order to fill it with water. On the bottom of the water tank, is placed the pipe of relatively small diameter, let us say less then ten centimeters. This will make the water flow pressure relatively constantly for the wide level range, of approximately half a meter water level in the tank. The water flow can run the turbine connected to the electric power generator to provide electricity. The rest of the water can rundown the slopes and irrigate the fields on plateaus. Dependently of the water spring capacity, it would be possible to drive a few such electrical power generator systems, placed around the spring. It wold be even possible to build the bigger water tank on the top of the hill and to use one of the generators to drive the water pump or even though the wind powered water pump to elevate the water and refill the tank. The water from the tank could drive the numerous turbines and enlarge the power of generated electrical energy. The central placed water tank could serve simultaneously as the resonant tower and improve the elevating of the groundwater and therefore the capacity of the spring.
Reversible water driven electric power generator
Imitating the natural processes, we would be able to significantly improve our technology. Using perpetual cycling of water in vertical direction, we would be able to make the simple gravitational power converter with considerably over unity effect, which means that additional environmental energy is going to be added into the system. This could be implemented to supply the water turbine driven electric power generator. The hart of the system is the feed back, which in this particularly case represents the water pump which elevate the water back to the tank. In similar way as already described at the beginning of this page, the properly selected water pump represents a key of success of this kind of application.
To make an power generator as described, we would need a water tank WT of cylindrical shape form, which is at least of double high then of its diameter. On the bottom of the water tank is placed a pipe of relatively small diameter, in order to provide the constant pressure water stream, to drain the turbine T. The electric power generator G is driven by the water turbine T. The turbine output water is going to be collected in the feedback water tank FB WT placed under the main tank. The electric powered water pump P is going to elevate the water from the feedback water tank FB WT back to the main water tank WT, in order to provide the water cycling in vertical manner.
While the electric power produced by generator G is far greater then the electric power used for supplying the water pump P which is necessary for providing the feedback, we are going to get the considerably amount of energy free of charge, cycling always the same quantity of water.
To illustrate how big difference is about, let us describe one real example. If we would have the water tank of one meter in diameter and two meters high, we can get 10 kW electric power using standard devices. To elevate the water two meters high, back to the main tank in order to provide the closed loop, we would need the water pump of approximately 250 W power or even less.
If we would need more generated power, we could just multiply the number of generators and place them around the water tank, in order to multiply the total power.
Successive chain water driven power generator system
It would be possible to implement simple power generator, as serial connection of many water stream driven power generators, using the water stream closed loop. It is going to significantly improve the efficiency of the power generating system. One of the generators can supply the water pump which is also connected in the same chain.
On this purpose it is necessary to develop appropriate turbines suitable to work in the given circumstances, connected in chain under the constant stream pressure. To magnify efficiency it would be possible to introduce the conic house, just before the turbine input, with spiral groove on the inner wall, to support water vortexes in order to enlarge water velocity in the closed loop. The water pump of appropriate properties has to be selected. It would be also possible to develop the serial chain power generator system, without any tank. Even though it would be possible to use another fluid instead of water, inside the pipes of the closed loop system. Just bear in mind that in case of water stream driven power generators of 30 kW power, we would need the water to circulate with over 100 liters per second with the pressure of four bar. The water pump is also going to be supplied by one of the generators.
Single tank water driven power generator
Accordingly to the difference among the electrical power consumption of the water pump and electric power production of the water turbine driven power generator, there is the real possibility to build closed loop system with over unity generating of electricity. On this purpose we would need to introduce only one closed water tank WT. In real example we could apply an electrical power generator G, model CJD-30 of 30 kW power which would need 90 to 120 l/s water to produce 400 V AC electricity of 50 Hz.
Furthermore we would need the water pump P, to provide the feed back, pumping the water back from the water tank WT to supply the generator G. In the real case we could use even the standard device such as Flygt 2700 water pump, which provides 80 l/s water using just 5 kW electrical energy to drive it. While needed water flow doesn't match exactly, we have to slightly enlarge the efficiency of the water flow, which is very easy to provide using the conic house build within the water pipe, with the spiral groove build on the inner wall of the conic hose. It is going to help the water to spin around the propagation direction and to magnify the flow.
While the water stream within the water tank WC is of very high pressure, we are going to build closed high performance water tank system. The barriers within the tank provides the water circulation of wished streaming patterns, to allow the water pump to work optimally. The water tank should be of few hundreds of liters capacity to allow the pump to be steady under the water level, because 100 liter is going to be circulated every single minute. Security valves have to be introduced, as well as the monitoring system for the water flow to ensure the water quantity within the tank.
Here described over unity system would produce 25 kW electrical power in the closed loop. To start the system it would be necessary to shortly apply external power supply to start the pump, and then to establish the closed loop, reconnecting the power supply of the generator, to the pump.
This type of electric power generators are of relatively small power, but still useful as small decentralized power generators. Furthermore, the system is scalable while connecting numerous small power units together could build one larger power system. To avoid the noise it is possible to install the system underground.
Also in this particularly case, as well as in cases described above, the usage of special designed water pump based on Tesla turbine, would significantly improve the final results.
Power generators with water column.
Compared to the previous type of power generator, this type does not need any initial power to start the self sustained running mode, because of implementing the water column. It would be possible to apply the larger power systems which need the water column, if we would install the water tank on the top of the hill, and then going around 50 m down the hill to install our pears of generators and water pumps, which we could multiply as many folds as needed. The single generator could also be of higher power, for example 100 kW each.
It would be possible to chain many turbines together, to reuse the same water stream, so we can get simple system as powerful as needed. Since the water is not compressible, there is nothing going to go wrong by simple connecting numerous generators after each other in the same water stream, so the water outlet of previous turbine is going to be the input for the next one. It would be easy to reconstruct the water input and output of the turbine to better match this purpose. In this case, additional energy is going to be introduced in the system implemented the combination of water head to a kinetic energy of water vortex which is going to be achieved using a spiral water pipe. To read about this idea described in much more details, please visit the Reversible Hydro Power Plants.
This kind of underground power generators would be possible to implement also in urban areas, and maybe also to replace particularly the step down power grid transformers, providing decentralized power supply.
It would be necessary to implement the closed loop systems for producing clean electricity in order to avoid the collapse of the planetary life. Inexpensive electrical energy could be provide in simple extensible way, in order to match into planed decentralized power grid constructed upon the fractal model. One part of generated energy could be reused to recharge the ground electricity and to repair the damages in ozone layer. As soon as the initial investment is going to be justify, all collections can be applied for expanding the capacity of the power plants, or some another aim.
Of this reasons it is advisable to carefully read what is already published on this sites, especially on
Understanding of this simple techniques is very important to successfully implement the described technology and to provide essential support for abundance of life, to allow the fresh water supply on very simple way as well as cheap electricity of very good quality. The vision of results of implementing suggesting methods is described in more details on next pages.
All systems described here are free of charge for non commercial use. Otherwise some small percentage of resoled energy unite whould be advisable to be paid to the authors account, to provide the fund to support for reconstructing the resonant landscape network worldwide, in order to recover the real interface to the whole living universe. All rights reserved, with the main goal to suppress any kind of monopoly, general representatives, exclusive rights on intellectual property or any ill competition, which all have considerably characterized the former age, resulting in magnifying the ignorance and hyper production of waste worldwide.
Since my financial situation is very bad, any financial support would be of immense significance to me and my family members, allowing me for realizing numerous projects, described at this sites.
