Direct energy conversion
Since we are living within the ocean of energy, which we call the Universe, situated at the ground surface, the conductive layer of global capacitor, charged with free electrons, and salt water ions, we could be capable to convert the universal energy directly, without to discharge the ground, thus without to lower the energy of global capacitor. Recently, we could be aware of wide used numerous inventions based on direct conversion of the ground electricity into another kind of energy, or into electrical energy of common purpose. These processes are leading to discharging the global capacitor, thus to decrease the electrical charge of crust and ionosphere correspondingly, which in turns decrees the density of energy-matter of Crust. The result is global disaster expressed in growing of the surface of devastating landscapes, increasing the seismic activities, and causing global catastrophe in general, which results finally in canceling the life on Earth. One example of such devices, which are very frequently and widely in use represents microwave oven, which high voltage dc circuit is pulling within itself the free electrons from the Crust, through the ground lead, at which 6 kV pulses of 50 Hz are pulsating, in order to provide converting of the electrical energy into electromagnetics radiation. Due to many millions of ovens used worldwide, the energy of the Crust is discharged, which produce global damages. The solution is very simple, one high voltage node have to be electrically insulated from the case of device, thus separated from the ground lead.
Being aware of these background information, we should avoid further development of such devices, which are discharging the Crust, and simultaneously develop such power devices, which are recharging the Crust and increasing the energy, thus matter density of the planetary Ground. We are going to go back on this subject later. What we could do, without to demolish the balance is to develop such energy converting systems, which are going to directly convert the energy from environmental surrounding energy field. In doing so, we are going to connect to, from our point of view, practically infinite source of energy, Universal battery.
Natural principles we could use are resonance power and universal fractal model with built in real-time feedback. This means that, we should develop and use the global monitoring, thus controlling system on this purpose, controlling in real-time the developing process, as well as spreading of direct energy conversing power plants. In doing so, nothing could go wrong. The principle of working of direct energy converting devices differ not from already described energy convertors, based on real-time closed loop, or positive feedback with built in controlled intensity and time line process. Furthermore, universal fractal model could be used for both implementation process, as well as positioning the power plants, in Fang Shui style, bearing always in mind the global aspect nearby the local needs. Just to reiterate, Fang Shui is ancient Chinese traditional knowledgebase, which serves to matching the planetary resonance and keeping the harmony, both locally and globally.
What we intend to do is to develop and install the power plant network across the globe, which is going to fulfill all our needs for energy. This power plant network should be completely in harmony with global oscillations, optimized on its impact toward the environmental surrounding, being of these reasons life supportive in general. The basic principle of direct convertors is fusion based generating of free electrons, which increases the intensity of electric current at the output of pulsed converter resonant circuit. We should bear in mind that generating process of free electrons at the ground surface is natural process. In general, the energy supply of planet Earth originates mostly of solar radiation, or more general expressed of cosmic radiation. Therefor, discharging the Crust, thus global capacitor, is disturbing the energy relationships in Solar system, causing the planet to slow down, among the others. Concerning that it is well known to an average reader that smallest material particle electron consists of spin and contra-spin, which are fused together in resonant conditions, building the smallest stable material particle at the ground surface. In the matter of fact, the two voltage vortexes of same intensity, and of opposite directions, are spinning in vacuum, thus oscillating at very high frequencies, coted in fixed universal resonant fractal frame, building under stable conditions the smallest material particle, carrier of free charge, the free electron. Understanding of these background information, is going to help us to easily understand the principal of fusing of the generated electric field vortexes, under the matching harmonically conditions with Earth’s resonant self-oscillations.
Our direct energy converting device, pulsing the high voltage along the u-shaped conductive lead, is generating the spin and contra-spin electromagnetic vortexes at certain distance of each another, which are going to be merged within the resonator, selected to harmonically matches the Earth’s self-oscillations. The higher pulse frequency the more generated electrons per second, thus the higher efficiency of converting device. What we have to know is that resonator is nothing else but simple coil, of certain length of wire, which matches the quarter, half, three quarter, one or better expressed the integer product of quarter of longitudinal wave length of planetary resonant oscillations. In this case, if we concern that the resonant frequency of planet amounts 8 Hz, the longitudinal quarter wavelength amounts two meters, which determines our wire length step. Thus the resonator’s coil consists of wire which length amounts the integer product of two meters. The u-shaped conductive wire, which is supplied by high voltage dc pulses is placed axial symmetrical within the coil. The last meter of the resonant coil wire is winded as second layer backwards, using the trifilar – three parallel conductive leads – of high frequency wire with such step to match approximately the half of the coil length. One end of the u-shaped middle wire is grounded, since another end represents common terminal of the energy converter. The electric current at the output of trifilar terminal of resonant coil is going to be higher then at input, depends on efficiency of the direct energy converter. This kind of fusion converter is well known from the beginning of radio technology, since the emitted power of first radio senders was higher then expected. Recently, Georgian invertor Tariel Kapanadze has invented numerous direct energy converting devices based on described principle, which is particularly replicated and online represented by J. L. Naudin.
The multiple optimization of the converting system could be performed. Since the frequencies of oscillation of electromagnetic vortexes, the constitutive structures of electrons are very high, and we would need to transfer the electrical current energy through the wire, rather than to convert it in radiation, we would need to use high frequency wire to make the resonant energy converter. This is well known from the physics lessons that at high frequencies the skin effect occurs, since the energy transmission carriers are pushed toward the conductor’s surface, thus the effective cross-section of the conductors is going significantly to be reduced at high frequencies. The work around could be achieved using the hf wire, which consists of numerous thin insulated wires, which are twisted in bundle and galvanic connected at both ends. This is to be proven if better results could be achieved using self-made hv wire, which consists of numerous thin standard cooper wires insulated with lack, without to twist them together, but rather to pool them into some flexible plastic tube, which is going to keep them in form, since along the twisted wire self-cancelation of the electromagnetic field occurs.
Another optimization consists of reshaping the resonator to match the ring form. In doing so, we are going to get closed circle, supporting the processes, which are occur in the u-shape wire placed along the middle line of the resonant coil. Next step would be to wind the sequential coil to match even better results increasing intensity of standing waves at higher harmonics of resonant frequency, which would significantly increase intensity of the direct energy converter. The wire length necessary to wind one sequence should match the metric, to keep the oscillations of the resonator to swing in harmony with the planet. Consequently, the size of ring should be carefully selected to match the needs. For illustration, the prototype coil represented schematic at the image above, consists of nine sequences of one-meter long wire plus one meter long wire for triffilar layer. The direction of winding of the coil plays significant role for properly working. If we start to wind the sequential coil from the top of the u-shape lead, the direction should be clockwise. It could be imaginable that the direction depends upon the Earth’s hemisphere, accordingly to opposite swirling directions of the water vortexes, which are related to the properties of the gravity force, therefor it should be checked.
Accordingly to the experiences of numerous inventers, implementing the ferrite ring core would also increase efficiency several folds. Even better results than achieved with the ferrite core, could be implementing of the magnet wire to wind the triffilar layer, since the magnetic flux along the wire is going to be amplified thousands folds, and to oscillate in parallel with electrical field across the wire. Accordingly to experiences of many inventors, winding the coils perpendicular to each another, such as in TPU converter case, is essential for getting the over-unity results. In doing so, in result we are going to get magnetic and electric field, which are oscillating in parallel along each other, rather then perpendicular to each another. Exactly the same effect, but maybe even much better results, we are going to achieve using the iron instead of cooper hf wire for making our triffilar coil layer. Since it is non-standard, we should make it ourselves, or we could even use some magnetic iron sail, just like this one, which is used for hanging the windows covers. If the strings were made of non stainless steel, thus slightly rusted along the whole length, this would provide enough insulation at high frequencies to match the aim of avoiding the skin effect. Consequently, joins at the both ends should be galvanic connected, for instance molting them together, then use of some standard thick wire hoses is going to allow for soldering, thus connecting to the rest of the circuit.
The block schema of the direct energy resonant convertor device is represented above. The energy conversion has to be initialized by high voltage dc pulses, which could be for instance just like these, which are given at the output of the high voltage fly-back circuit convenient used in tv-set devices. At the output of resonant converter we’re going to get the same dc pulses as at the input, just of higher power, thus for supplying the standard consummator we would need step-down convertor, which are going to give at its output standard ac power. This is however the most complex block of the device, since it should convert high frequency high voltage pulses into the low frequency low voltage standard power supply. The closed loop is going to be automatically established after the energy converting process starts to run, and simultaneously the battery supply, necessary only for startup is going to be disconnected. Exactly the same device, just simplified, could be used in numerous examples, to recharge the Ground Crust of the planet Earth with generated electricity, in order to reveal the lost global balance, and allow for supporting the global life in general. The detailed description of the Crust recharging device is published at online presentation.
The whole class of direct energy conversion devices is the most efficient kind of all energy conversion devices, since only one energy conversion process is implemented within the energy workflow, thus the losses are going to be minimized. Therefor it is to expect that not only efficiency, but also the power-to-volume ratio is going to be highest by this class of energy converting devices. The power dissipation in form of increasing the temperature, is going to be expected in devices block which is converting the low voltage dc power into the high frequently high voltage dc pulses, as well as in devices block which is converting the high frequency, high voltage pulses into low voltage, low frequency ac power. The feedback circuit which converting the standard low voltage low frequency ac output power, to the low voltage dc input power, is also going to produce dissipation. Once the loopback is closed, the battery could be disclosed from the rest of circuit. The resonant energy convertor device is going to get colder then environmental temperature, the more cold the higher power is going to be generated.
To reiterate one more time, the aims of this work are to contribute to the workaround for non-avoidable global industrial energy transition, developing devices and strategies, which are going to reveal the lost natural balance, and to preserve the overall harmony long term, along with allowing for huge wins, which are going to accumulate along the time. This is winning strategy, which allows for avoiding of any collapse, regardless if it is about industrial, business, private property, and life in general.
To allow for realization of these aims, the fundaments must be slightly but significantly rearranged, along with choice of wide implemented strategies. We would need to replace dualistic principles based on lovers which are fighting for might, which results in master-slave relationship, with principles of lovers which are free and supporting each other, along with replacing the blind hierarchy chain-reaction avalanche model without any feedback, thus demolishing, explosion related, fission model, with universal fractal model, which is fusion related, based on transparent unified information-energy-matter flow, and real-time feedback without any distortion of information. Since the blind chain-reaction model is producing collateral damages and waste, which are accumulating along the time, the fusion-based model is introducing non-blind, non-destructive resonant power, which self-sustained amplification is limited by implemented real-time feedback, accordingly to expected output results. Therefor it is winning related strategy model in general, since wins are our aims, rather then losses.